![]() Another method is to drive in mounting screws that affix to the bracket and hold the bumper in place. One way is to slide the bumper over the top of the mounting bracket and secure it with a cap. Step 4- Install BumperÄepending on the type of dock bumper you have, this step can be done in several different ways. Repeat as necessary for the other holes if any. You may have to reach under, or get into the water if it is too much of a reach. Use your socket wrench and tighten up the bolt from the underside of the dock. Place the bracket back on to the dock and slide the bolt through the hole. ![]() Use your cordless drill with the right size drill bit to drill the hole. ![]() Place a small level on it to make sure it is level and mark the holes with a marker. Take the mounting bracket that the boat dock bumper will be attached to and line it up on your wood dock. This is where the middle of bumper should be. The best way to do this is to pull your boat alongside and mark the wooden dock where the railing is. If you put the bumpers up too high, the boat will slide under them and they are useless. Step 2- Measure for Right HeightĪfter you have measured the dock and determined where the dock bumpers will be placed, you will need to measure down towards the water for the best height. Once you decide that, just use two for each boat. Measure your overall dock and decide on how many boats will fit there. As a general rule, each boat you will be tying to the dock should have at least two that will keep it away from the dock. Before you begin installing any dock bumpers, you must know how many you are going to need. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |